C-Slow Compensation

3 posts / 0 new
Last post
Olf23
Olf23's picture
C-Slow Compensation

 Hi guys, 

I have a problem with C-slow compensation, my R-series is very high always 9999.9 Mhom.  The auto compensation is not working in PATCHMASTER. But it works by selecting the 100 pF range from the Range field (compensation by hand)
Do you have any suggestion about the C-slow auto compensation?

Thank you in advance for your answers.

Regards,

Olf23

c.hill
c.hill's picture
I never use the AUTO button

I never use the AUTO button for C-slow because it gives me crazy numbers (extremely low pF and extremely high Mohm). I tend to set the range from Off to 30pF, where C-slow is automatically set to 50pF and R-series to 20Mohm. I then manually turn down the pF and Mohm.

I hope that helps,
c.hill

Olf23
Olf23's picture
 Hi c.hill, 

 Hi c.hill, 

Thank you for your answer. It was the wrong spelling in the commands in the protocols. I rectified it now evrything works fine. I got help from Heka support they are very nice!
Greetings, 

Olf23